Access LED does not go out after power up

Symptom: Access LED and motor do not go out after power up.
Target : -


Possible sources of failure
  - serial cable -> continuous reset
  - 74LS14
  - <>5V
  
Analysis
Cable ok?
 
  Try a different serial cable. If it works, buy a new cable. The
  old one is damaged and causes a continuous serial reset.
 
71LS14 ok?
 
  Exchange the 71LS14 located near the serial input/output jacks.

The following procedures require a multimeter or a logic tester.

  Blah...

This document is part of MJK's Commodore 64 & LCD Page Brought back to life by Peter Schepers, Dec 10, 2005 because I really liked this site!

Access LED does not go out after power up

Possible sources of failure

Analysis

Site copyright © 1997 by Marc-Jano Knopp