MainHELP Glossary Hardware SAL Workshop Companies FTP ToolsBackAbout

Motor does not work.

Symptom: Drive resets, but motor does not spin.
Target : all serial floppy drives

Possible sources of failure

- rectifier - electrolytic capacitor - voltage regulator


Note: The following procedures require a multimeter.
Rectifier ok? Measure the voltage on the electrolytic capacitor. If it is far below 15-20V, replace the rectifier with a B 40 C 2200. Electrolytic capacitor ok? Blah... Voltage regulator ok? Blah...

Site copyright © 1997 by Marc-Jano Knopp
This document is part of MJK's Commodore 64 & LCD Page
Brought back to life by Peter Schepers, Dec 10, 2005 because I really liked this site!